The platform should have vertical and horizontal supports especially if its for 2 people. Origami Angel made with 3 one dollar bills.
Then you will cut the plywood for the top of your platform.
How to fold a car. The halo is a decorative wedding band. Step 1 Wipe the tray clean. You wont want a wobbly or unstable platform.
The flower and bow are glued to a button. How should I fold and store my Coverking Car Cover. Dry the tray with a clean towel after washing itStep 2 Locate the side handle buttons.
A piece of letter-size paper folded in half makes a single portrait card that measures 85 inches by 55 inches. Click on our logo at any time during this video to open our webs. Flatten the Fold.
Bring the front and the back of the Coverking Car Cover to the center of the vehicle then roll-up or fold your Coverking Car. Clean any spilled food or drink off the tray with a soft damp cloth. Each wing is a dollar and the gown is one dollar.
Carefully fold the card along the scored line. This way you dont drag the cover over the vehicles surface and its easy to reverse the process for installation. The button is attached to the wire that holds the dollars together as well has the bead head and halo.
The first step for the origami car get a sheet of paper and start with the white side up. Press firmly but not so hard that you mark the cardstock. Yes your EmpireCovers car cover WILL fit back into the little bag it came with.
The side handle buttons are located along the underside of the tray. Simply fold each side up onto the roof and refold it as necessary so the material ends up about 2 feet wide. Hold the paper lengthwise and fold it in half side to side.
Use the bone folder or another flat implement to flatten the fold. What were going to do is were going to fold the bottom edge up to the top edge and this is a book fold. Do not attempt to wash the tray in a dishwasher.
Bring all four sides of the cover to the roof area in two-foot increments. Do not drag or pull Coverking Car Cover to remove it. A piece of letter-size paper folded in half makes a card thats sized 425 inches by 55 inches.
Make sure that its nice and lined up so that theres no extra white showing. After your car is measured cut the lumber to the correct sizes and drill them together with screws. Then starting at the front of the vehicle fold the cover towards the back in increments of about 3 feet.
Step 1 Release both ends of the cover from under the bumpersStep 2 Fold up both sides onto the top of the vehicle into a long pile approximately 2 feet 60 cm wideStep 3 Start at the front of the vehicle and fold the cover in three foot 1 meter folds. Periodically clean the tray with soapy water and a clean soft cloth to sanitize it. Get each of those to line up as nice as you can and then make a good.